Mitsubishi Electronics WD-52526 manual Audio/Video Menu

Chapter 4. TV Menu Operations 53

Audio/Video Menu

Audio/Video Menu

Figure 13

Figure 13. Audio/Video Menu

A/V Memory Reset

A/V Memory Reset allows you to reset the A/V settings for a specific input or device to the original factory set- tings. Use ADJUST or to select the input or device in the box and press ENTER. Note that the audio settings of Balance, Listen to, and Language are general TV settings unaffected by A/V Memory Reset.

To reset all A/V settings at once, including the three general settings, perform an A/V Reset by pressing the front-panel buttons GUIDE and FORMAT simultaneously.

Settings

Each input or device has its own A/V memory. Select the input or device in the A/V Memory Reset box, then select Audio or Video to adjust individual settings. Press ENTER to close the menu and display the individual settings.

Use ADJUST or to select the individual settings to adjust. Use ADJUST or to make changes. For descriptions of the individual A/V settings, see the section entitled “Audio/Video Menu” in chapter 4.

Video Mute

Video Mute lets you display a blue background when no signal is being received on INPUT 1–3, COMPONENT 1 and 2, or HDMI 1 and 2.

Film Mode (480i signals only)

Auto is the default setting. With Auto selected, the TV automatically detects and applies film-decoding correc- tion for images that originated on 24-frame-per-second film cameras and were then converted to 30-frame-per- second video for broadcast. Try the Off setting if the TV adds too many jagged edges to the images.

When the original video was filmed on 30-frame-per- second cameras, the Auto setting automatically applies video decoding, the same as is used with the Off setting.

Film Mode is not effective for high-definition signals.

TV Speakers

This selection turns the TV’s internal speakers on or off. You may select Off when sending the sound through a separate stereo system or surround sound A/V receiver.

Note: To prevent damage from a sudden increase in volume, make sure the TV volume is set to low before setting speakers to On.

Using the AUDIO or VIDEO Button on the Remote Control

To adjust individual Audio or Video settings directly with the remote control:

1.Press AUDIO or VIDEO.

2.Press ADJUST or repeatedly to cycle through the available options.

3.Press ADJUST or to change the setting. After five seconds of inactivity, the setting display will dis- appear.