Mitsubishi Electronics WD-52527 manual For antennas with flat twin leads

Connecting an Antenna with a Single Lead or Antennas with Separate UHF and VHF Leads

Antenna with Single Lead

(not for use with CableCARD™)

Figure 3

A300-Ohm to 75-Ohm transformer is required. This is not included with the TV, but is available at most electronics stores.

Antennas with Separate UHF and VHF Leads

Figure 4

A UHF/VHF combiner is required. This is not included with the TV.

For antennas with flat twin leads

1.For an antenna with flat twin leads, connect the 300-Ohm twin leads to the 300-Ohm to 75-Ohm transformer.

2.Push the 75-Ohm side of the transformer onto ANT-1 MAIN on the TV back panel.

For cable or antenna with coaxial lead

3.Connect the coaxial lead directly to ANT-1 MAIN on the TV back panel.

0IN	0IN
'MBU5XJO	$PBYJBM
-FBE	$BCMF
			57 CBDL QBOFM TFDUJPO
			DTV/CABLE/
			VHF/UHF
			USE WITH
			CableCARDTM
			ANT 1 / MAIN
	
	0QUJPOBM 0IN
	UP 0IN
	.BUDIJOH 5SBOTGPSNFS

Figure 3. Connecting a Single Antenna

1.Connect the UHF and VHF antenna leads to the UHF/VHF combiner.

2.Push the combiner onto ANT-1 MAIN on the TV back panel.

7)' "OUFOOB	6)' "OUFOOB
$IBOOFMT 	$IBOOFMT 
'MBU 5XJO -FBE	'MBU 5XJO -FBE
&YUFSOBM
"OUFOOB
PS $BCMF
	 0IN UP		57 CBDL QBOFM TFDUJPO
	 0IN
	$PNCJOFS
	6)'		DTV/CABLE/
			VHF/UHF
			USE WITH
	7)'		CableCARDTM
			ANT 1 / MAIN
	#BDL	4JEF
	

Figure 4. Connecting separate UHF and VHF Antennas

Mitsubishi strongly recommends you avoid using antennas with flat twin leads. Flat twin lead antenna wires are subject to interference which may adversely affect the performance of the TV. We recommend using coaxial antenna cable.

Chapter 2. Connecting 25