Mitsubishi Electronics WD-52725, WD-62525, WD-52525, WD-62725 manual Wall Outlet Cable

Connecting a Wall Outlet Cable or Cable Box

Wall Outlet Cable

(can be used with a CableCARD™)

Figure 1

It is very important to connect the incoming cable for your primary viewing source to ANT-1, especially for CableCARD™ use.

1.Connect the primary incoming coaxial lead cable to ANT-1 MAIN on the TV back panel.

2.For an optional secondary antenna source, connect an antenna (or cable) to ANT-2 AUX.

3.If you have subscribed to a CableCARD™ service, the CableCARD can now be inserted into the CableCARD SLOT. Using a phillips screwdriver, remove the CableCARD cover screws. Insert the CableCARD, then replace the cover and screws. Additional CableCARD information is on page 18.

TV back panel section

Cable Box (compatible with PIP/POP)

Figure 2

3 coaxial cables and one two-way RF splitter are required. These are not included with the TV.

It is very important to connect the incoming cable for your primary viewing source to ANT-1, especially for CableCARD™ use.

1.Connect the incoming cable to IN on an RF splitter.

2.Connect one coaxial cable from OUT on the RF splitter to ANT-1 MAIN on the TV back panel.

3.Connect one coaxial cable from OUT on the RF splitter to IN on the cable box.

4.Connect one coaxial cable from OUT on the cable box to ANT-2 AUX on the TV back panel.

Cable Box
back panel section
3.	TV back panel section

2.Optional Secondary Antenna or Cable

1.Primary Wall Outlet Cable

ANT-2

AUX

DTV/

CABLE/

VHF/

UHF

ANT-1

MAIN

		IN
		OUT	4.	4.
				ANT-2
				AUX
				DTV/
				CABLE/
			3.	VHF/
				UHF
1.
	SPLITTER	OUT		ANT-1
				MAIN
IN				2.
	TWO WAY
Incoming		OUT
Cable			2.

Figure 2. Connecting a Cable Box

CableCARD	TM	3.	TMCableCARD	TOP
				CARD
SLOT			SLOT
(cover removed)

Figure 1. Wall Outlet Cable

Note: Net Command® will assume that your Cable Box is connected as shown above. Also, that Channel 3 is the default output channel for the cable box. If either the connections or output channel are different, use the Change option of Edit NetCommand to apply the changes.

IMPORTANT

Additional connection cables are not provided with the TV. They are available at most electronic stores.

17