Mitsubishi Electronics WD-52725, WD-62525, WD-52525, WD-62725 manual

Connecting a DVD Player with Component Video or Computer with a PC Monitor Output

DVD Player with Component Video

Figure 9

Component video cables and audio cables are required. These are not included with the TV.

1.Connect the Component Video cables from Y/Pr/ Pb VIDEO OUT on the back of the DVD player to COMPONENT-1 on the TV back panel, matching the correct connection:

•Y to Y (Green)

•Pr to Pr (Red)

•Pb to Pb (Blue)

2.Connect a set of audio cables from AUDIO OUT on the back of the DVD player to COMPONENT-1 AUDIO Input on the TV back panel. The red cable connects to the R (right) channel, and the white cable connects to the L (left) channel.

	TV back panel
					2.
				Red		White
								COMPONENT-1
								YPbPr (480i/480p/720p/1080i)
								1
DVD back panel
1.			AUDIO OUT
								AC IN
Y	VIDEO	5.1 CH SURROUND	2CH	BITSTREAM/PCM	MITSUBISHI		White
		CENTER			DVD PLAYER
CB			L
	S							2.
CR			R
VIDEO OUT		SUBWOOFER SURROUND	FRONT			Red
Figure 9. Connecting a DVD Player with Component
Video

Note: NetCommand® will assume you connected your DVD player to Component-1. If you add a second DVD or use any other inputs for your DVD, this change must match in the NetCommand system. See Edit NetCommand...

in Chapter 3 for more information.

IMPORTANT

See Appendix B for component video signal compatibility information.

For digital audio connections, see your

DVD Owner’s Guides.

Computer with a PC Monitor Output

Figure 10

1.Connect PC Monitor Out from the computer to PC Input on the TV back panel using a PC compatible monitor cable. See Appendix B for PC signal compatibility.

2.Connect the L (left) and R (right) audio cables from the computer to PC AUDIO on the TV back panel. In cases where your computer’s audio output is a single mini-jack, a splitter is needed to complete this connection.

Note: To utilize the benefits of a digital A/V receiver, connect your computer’s digital audio out, if available, to a digital input on your digital A/V receiver.

TV back panel (section detail)

PC

VGA/SVGA/XGA/

720p

60 Hz

L

R

PC-

AUDIO

PC-

INPUT

Computer with Monitor Output

Figure 10. Connecting a Computer with a PC Monitor

CAUTION: To ensure continued FCC compliance, the user must use a shielded video interface cable with bonded ferrite cores at both ends when using the PC input.

23