Mitsubishi Electronics WD-62825 manual Connecting a Lead Antenna or Separate UHF and VHF Antenna

Connecting a Lead Antenna or Separate UHF and VHF Antenna

Lead Antenna (not for use with CableCARD™)

Figure 3

Separate UHF and VHF Antenna

Figure 4

A UHF/VHF combiner is required. This is not included with the TV.

For antennas with twin flat lead		1. Connect the UHF and VHF antenna leads to the
A 300-Ohm to 75-Ohm transformer is required. This is not
		UHF/VHF combiner.
included with the TV, but is available at most electronics
stores.		2. Push the combiner onto ANT-1 MAIN on the TV
1. For antenna with twin flat leads, connect the		back panel.
300-Ohm twin leads to the 300-Ohm to 75-Ohm		VHF Antenna	UHF Antenna
transformer.
		(Channels 2-13)	(Channels 14-69)
2. Push the 75-Ohm side of the transformer onto ANT-1
MAIN on the TV back panel.		Flat Twin Lead	Flat Twin Lead
		External
		Antenna
For cable or antenna with coaxial lead		or Cable			TV back panel section
3. Connect the coaxial lead directly to ANT-1 MAIN on
the TV back panel.
			300 Ohm to		CABLE/
			75 Ohm
			Combiner		DTV/
					UHF
	TV back panel section				VHF/
			UHF	2.
					MAIN
					ANT-1
			VHF
			Back	Side
300-Ohm	75-Ohm		1.
FlatTwin	Coaxial
Lead	Cable

3.	Figure 4. Connecting separate UHF and VHF Antennas
	DTV/
	CABLE/
	VHF/
	UHF

ANT-1

MAIN

2.

1.

Optional 300-Ohm

to 75-Ohm

Matching Transformer

Figure 3. Connecting a Single Antenna

Mitsubishi strongly recommends against using antennas with twin flat leads. Twin flat lead antenna wires are subject to interference which may adversely affect the performance of the TV. We recommend using coaxial antenna cable.

21