Mitsubishi Electronics WD-62825, WD-52825 manual Connecting a Cable Box to a VCR Audio & Video

Connecting a Cable Box to a VCR (Audio & Video)

Cable Box to a VCR (Audio & Video)

Figure 6

A two-way RF splitter, 4 coaxial cables, right and left audio cables and an S-Video or Video cable are required. These are not included with the TV.

1.Connect the incoming cable to IN on the RF splitter.

2.Connect one coaxial cable from OUT on the RF splitter to ANTENNA IN on the cable box back panel.

3.Connect one coaxial cable from OUT on the RF splitter to ANT-1 MAIN on the TV back panel.

4.Connect one coaxial cable from OUT on the cable box to ANTENNA IN on the VCR back panel.

5.Connect one coaxial cable from ANTENNA OUT on the VCR back panel to ANT-2 AUX on the TV back panel (optional).

6.To use the TV speakers with the VCR, connect a set of audio cables from AUDIO OUT on the VCR back panel to INPUT-1 AUDIO-LEFT (MONO) and AUDIO-RIGHT on the TV back panel. The red cable connects to the R (right) channel and the white

cable connects to the L (left) channel. If your VCR is mono (non-stereo), connect only the white (left) cable.

7.Connect either an S-Video or Video cable from VIDEO OUT on the VCR back panel to INPUT 1 VIDEO on the TV back panel. Only one type of video cable should be connected. S-Video is recommended, if available.

8.For NetCommand® controlled recordings, connect a set of audio cables from AUDIO IN on the VCR back panel to MONITOR OUTPUT AUDIO/VIDEO 1 AUDIO-LEFT (MONO) and AUDIO-RIGHT on the TV back panel. The red cable connects to the R (right) channel and the white cable connects to the L (left) channel.

9.Complete the NetCommand controlled recordings connections by connecting a Video cable from VIDEO IN on the VCR back panel to MONITOR OUTPUT AUDIO/VIDEO 1 on the TV back panel.

1.	SPLITTER	OUT
IN
Incoming	TWO WAY	OUT
Cable

Cable Box

back panel section2.

IN

OUT4.

				8.		9.
		TV back panel section
				IEEE1394
			INPUT/OUTPUT
			IR EMITTER	PC
			NetCommand	VGA/SVGA/XGA/
				720p	AUDIO		MONITOR
				60 Hz	L(MONO)	VIDEO S-VIDEO
				R			OUTPUT
			DVI	L
3.		L					AUDIO 2
	5.		Analog Audio
		R	ANT-2	R
			AUX	PC-			AUDIIO//VIIDEO 1
				AUDIO
			DTV/
	3.		CABLE/				INPUT-1
			VHF/
2.			UHF
		HDMI	ANT-1	PC-			INPUT-2
		M-LINK	MAIN	INPUT
			M-LINK
			CONTROL/
			RS-232C	DIGITAL
				AUDIO

6. 7.

Attach only one cable type

		8.
VCR back panel
�� �����		4.
		5.
If your VCR has a video channel	6.
or RF ON/OFF switch, set it to OFF.
7.
S-Video	7.	9.
recommended

if available

Note:

NetCommand® will assume your VCR is connected to inputs as shown on this page.

If you use any other inputs for your VCR or add a second VCR, this change must match in the NetCommand system.

See Edit

NetCommand...

in Chapter 3 for more information.

Figure 6. Connecting a VCR to a Cable Box

23