Mitsubishi Electronics WD570U, XD560U user manual Menu operation

Menu operation

You can make various settings using the displayed menus.

Picture

Image

Brightness

Contrast

Color Temp.

Color Management

Aspect Ratio

Input Level

3D

3D Sync Invert

Auto
Theater
Presentation
Standard
Black Board
White Board		Brilliant Color™
User		Gamma
±30		Contrast R
±30		Contrast G
Low		Contrast B
Mid		Brightness R
High		Brightness G
User		Brightness B
Red		Gain
Green		Saturation
Blue		Hue
Cyan
Yellow
Magenta
Normal
16:9	*7	Center, Upper, Lower
Full
Auto, Normal, Enhanced
Off, On
Off, On

0-10

Dynamic, Natural, Detail

±30

±30

±30

±30

±30

±30

±30

±30

±30

*8

Video Image

Signal

Audio

Installation

Option

Network Config

Information

Color	*1	±10
Sharpness	*1	±5
Tint	*1	±10

H.Position		0-999		*4
V.Position		0-999		*4
Fine sync *1*2		0-31
Tracking	*2	0-2800		*4
Computer Input	*2	Auto, RGB, YCbCr/YPbPr
Overscan		90-100%		*4
Hold	*2	On				Begin		0-99
		Off				End		0-99
User		OK			Clamp Position		*2	1-255
					Clamp Width		*2	1-63
						LPF	*1*2	On, Off
						Shutter(U)		0-20
						Shutter(L)		0-20
Audio Input		Auto
		Audio 1	*6			Shutter(LS)		0-20
						Shutter(RS)		0-20
		Audio 2	*6
		Audio 3	*6
		Mix	*6		±10
Volume		0-21
Menu Position		Upper Left, Upper Right, Center, Lower Left, Lower Right
Lamp Mode		Standard, Low
Standby Mode		Low, LAN, Speaker Out, Monitor Out
Image Reverse		Off, Mirror, Invert, Mirror Invert
Auto Power On		Off, On
Auto Power Off		Off, 5Min, 10Min, 15Min, 30Min, 60Min
Auto Keystone		Off, On
Language		English,		, Español, Français, Italiano,				, Deutsch,	, Polski, Português,	, Svenska, Indonesia, , Türkçe, Magyar,	, Bahasa Malaysia
Reset All		OK

Password		OK	Password	Off, On
			Change Password	xxxx
Cinema Mode	*3	Auto, Off
Video Signal	*5	Auto, NTSC, PAL, SECAM, 4.43NTSC, PAL-M, PAL-N, PAL-60
WXGA	*2	Off, Auto, 1280x768, 1280x768RB, 1280x800, 1360x768, 1366x768
Set Up	*1	Auto, Off, 3.75%, 7.50%
Image Capture		OK
Splash Screen		Original, User, Off
Back Color		Blue, Black, Image Original, Image User
AV Mute Mode		Black, Image Original, Image User
Closed Caption	*1	Off, CC1, CC2, CC3, CC4, T1, T2
Projector Name		xxxxxxxx..., SET
Network Certification		On , Off
Network Password		OK
IP Config		OK	DHCP	On, Off
			IP Address	0-255
			Subnet Mask	0-255
			Default Gateway	0-255
			MAC Address	xx-xx-xx-xx-xx-xx
			DHCP Function	Off, On
			Start IP Address	0-255
			End IP Address	0-255
			IP Config Setup		OK
Wireless Setting		OK	SSID	xxxxxxxx..., SET
			Channel	Auto, 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11
			Encryption	SET	, Off, WEP 128bit(ASCII), WEP 64bit(ASCII), WEP 128bit(HEX), WEP 64bit(HEX),
				WPA-PSK(ASCII), WPA2-PSK(ASCII), WPA-PSK(HEX), WPA2-PSK(HEX)
			Wireless Setup		OK
AMX Device Discovery		Off , On
Network Initialization		OK
Network Restart		OK

Lamp Time	*1: Not available with certain signals.
Input
Resolution	*2: Not available when the input signal is from the VIDEO or S-VIDEO terminal.
H.Frequency
	*3: Available only when the input signal is TV60, TV50, 480i, or 576i.
V.Frequency
	*4: The range that can be specified varies		across input signals.
Sync. Type *2
	*5: Available only when the input signal is from the VIDEO or S-VIDEO terminal.
	*6: Audio 1, Audio 2, Audio 3, and Mix		cannot be selected when the input source is HDMI input.
	*7: “	” is not displayed and is not available in WD570U.
	*8: This function is not available in WD570U.

EN-20