Mitsubishi Electronics WD570U, XD560U user manual Indicators, Normal condition, Abnormal condition

Indicators

This projector has two indicators, each of which shows the operation condition of the projector.

The following offer solutions to possible problems. If these problem persist, turn the projector off and consult your dealer.

STATUS indicator POWER indicator

Normal condition

POWER	STATUS		CONDITION	NOTE
		Off	Stand-by
Steady red			Lamp stand-by for power-off	The power cannot be turned on by pressing
	Blinking green			the POWER button.
			Lamp stand-by for power-on	The power cannot be turned off by pressing
	Blinking green			the POWER button.
Steady green
			The power is on. (Normal condition)
	Steady green

Abnormal condition

POWER		STATUS			CONDITION	POSSIBLE SOLUTION
					Abnormal temperature	• Clean the ventilation grilles.
Steady green					• The ventilation grilles is clogged with dust	• Relocate the projector to a cooler place.
	or				or dirt.
		Blinking orange
					• The room temperature is high.
Steady red
					The protection circuit is working or the lamp is	• Wait until the STATUS indicator goes
					in an abnormal condition.	out, then press the POWER button.
Steady red		Blinking green				• If the above solution is not effective,
						replace the lamp.
					The lamp operation time exceeds the time	Replace the lamp.
					elapsed until the lamp lifetime notice while the	Change with a new lamp if this problem
Steady green		Blinking green/red
					power is on. (See page 51.)	recurs.
					The lamp operation time exceeds the time
					elapsed until the lamp lifetime notice while the
Steady red		Blinking red
					power is off. (See page 51.)
					The lamp operation time exceeds the time
Steady red		Steady red			elapsed until the lamp lifetime. (See page 51.)
					The lamp cover isn’t closed.	Close the cover correctly.
			Off
Blinking green/red
					Abnormal.	Contact your dealer.
		Steady
				or
Blinking green/red
		Blinking

EN-56