Dell GX1 Connecting Peripheral Devices, O Ports, Connectors, and Indicators

Introduction: Dell OptiPlex GX1 Low-Profile Managed PC Systems

Passwords

The password feature enables you to set a user-defined password to restrict access to the system. Additional protection is available through the System Setup program. When the Setup Password option is set to Enabled, Password Status allows you to prevent the system password from being changed or disabled at boot time. For more information, see "Using the System Setup Program."

Connecting Peripheral Devices

Figure 3 shows the connectors on the back of your computer for attaching external devices.

Figure 3. I/O Ports, Connectors, and Indicators

When you connect external devices to your computer's back panel, follow these guidelines:

Check the documentation that accompanied the device for specific installation and configuration instructions.

For example, you must connect most devices to a particular input/output (I/O) port or connector to operate properly. Also, external devices like a mouse or printer usually require you to load device drivers into system memory before they will work.

Always attach external devices while your computer is turned off. Then turn on the computer before turning on any external devices, unless the documentation for the device specifies otherwise. (If the computer does not seem to recognize the device, try turning on the device before turning on the computer.)

NOTICE: When you disconnect external devices from the back of the computer, wait 5 seconds after turning off the computer before you disconnect any devices to avoid possible damage to the system board.

file:///C/infodev/2013/eDoc/OpGX1/SQRG/introduc.htm[2/21/2013 11:52:57 AM]