Mitsubishi Electronics XD700U, WD720U user manual Signal menu, Rgb, Lpf, User

Menu operation (continued)

Signal menu

		Signal
H. Position						0
V. Position						0
Fine sync						0
Tracking					0
Computer Input			Auto
Overscan		90%
Hold			On
User			OK
	Adjust		MENU	Exit
	Select

		User
Clamp Position					1
Clamp Width					1
LPF			Off
Shutter(U)					0
Shutter(L)					0
Shutter(LS)					0
Shutter(RS)					0
	Adjust			Exit
			MENU
	Select

ITEM	SETTING	FUNCTION
H. Position	0-999	Select this setting to adjust the horizontal position of projected images.
V. Position	0-999	Select this setting to adjust the vertical position of projected images.
Fine sync	0-31	Select this setting to eliminate flickering or blurs, if they appear, when you are
		viewing projected images.
Tracking	0-2800	Select this setting to eliminate vertical wide stripes, if they appear, when you are
		viewing projected images.
Computer Input	Auto	Automatically sets the appropriate setting.
	RGB	Select this setting when you connect the projector to high definition video
		equipment having R, G, and B output terminals.
	YCbCr/YPbPr	Select this setting when you connect the projector to a DVD player or other device
		having Y, CB, and CR (or Y, PB, and PR) component video output terminals.
Overscan	100%-90%	Use this setting to adjust the display area of projected images.
Hold	Off / On	Use this setting to adjust projected images when flagging occurs in the upper
		area of the screen.
User	OK	The Signal-User menu is displayed for the following adjustments.
Clamp Position	1-255	Use this setting to correct solid white or solid black that appears in projected
		images.
Clamp Width	1-63	Use this setting to correct solid black that appears in projected images.
LPF	On / Off	Select this setting to enable or disable LPF.
Shutter(U)	0-20	Use this setting to adjust projected images when noise appears in the top
		part of the image.
Shutter(L)	0-20	Use to adjust the image when noise appears on the bottom part of the image.
Shutter(LS)	0-20	Use this setting to adjust projected images when noise appears in the left half
		of the image.
Shutter(RS)	0-20	Use this setting to adjust projected images when noise appears in the right
		half of the image.

•Horizontal strips may appear in the enlarged projected image, though these conditions are not a malfunction.

•When you change the value of the horizontal or vertical position drastically, noise may appear.

•The adjustable range of the vertical position varies depending on the type of the input signal. The image may be stationary even when the value is changed. These conditions are not a malfunction.

•Shutter does not work correctly during keystone adjustment.

•When you increase the value of Overscan, noise may appear on the screen.

Important:

•You can set the Picture, Signal, and Signal-User menus only when the signal is inputted.

EN-25