Mitsubishi Electronics WT-42315 manual Composite Video with Audio or S-Video with AudioRecommended

Connecting an Antenna to a Cable Box and VCR, Connecting Audio/Video to the Cable Box or VCR

Note: The TV back panel and connections shown here are for reference only and may vary by model.

Contact your local cable or satellite provider or refer to the cable box or satellite Owner’s Guide for instructions on optimal connections to this TV.

a Cable Box and VCR the Cable Box or VCR

�� ���� ����� �������� �������
	��� �			�� �� �
�������� �����	�� � � �	���
�
			�	�
����� ���
���� ���������
�	�
���	��
��� ���� �����
�	����� ���		����� ��	����� ���
��	�		�	�����
�������	�		�	�
				�������
	�		�
	�
���

Cable Box

(Figure 5)

1.Connect the incoming cable to ANT-A on the TV back panel.

Connect three coaxial cables as follows:

2.One from LOOP-OUT on the TV back panel to IN on the back of the cable box.

3.One from OUT on the back of the cable box to ANTENNA IN on the VCR back panel.

4.One from ANTENNA OUT on the VCR back panel to ANT-B on the TV back panel.

Note: For best performance, please see Composite Video with Audio or S-Video with Audio, below.

to to

Figure 5. Connecting the VCR with cable box.

Connecting an Antenna Connecting Audio/Video

Additional connection cables are not provided with the TV. They should be available at most electronic stores.

		�� ���� �����
		�������� �������
			� � � � �
		�	�
						������������ �� ����������
				�������
							�	������ ����
								��� ����� ����
				� � � ��
	�����			������
				���� �
�				������
				������
				�����
	���
								�
								������
								����
								���
								�����
	��� ���� �����							����
								�
				����� ���		����� ��	����� ���
	�	��	�����	�		�		�����
		�������		�	�		�
			���				�������
				�		�
�� ���� ��� ��� � �����
������� �� �� ������		���
������� ��� �� ����

Figure 6. Connecting the VCR Audio/Video.

Composite Video with Audio or S-Video with Audio(Recommended)

(Figure 6)

1.Connect a video or an S-Video cable from VIDEO OUT on the VCR back panel to VIDEO or S-VIDEO, INPUT-1 or INPUT-2 on the TV back panel.

2.Connect a set of audio cables from AUDIO OUT on the VCR back panel to AUDIO INPUT-1 or INPUT-2 on the TV back panel, matching the input used in step 1.

•The red cable connects to the R (right) channel

•The white cable connects to the L (left) channel

If your VCR is mono (non-stereo), connect only the white (left) cable.

You may connect to the S-VIDEO or VIDEO terminal but not to both.

16