Mitsubishi Electronics manual Terminal Cover Ventilation for Model WT-42315, Stand Requirement

Terminal Cover Ventilation for Model WT-42315

Stand Requirement

CAUTION: This PTV for use only with Mitsubishi

Wall stand MB-42413. Use with other stands may result in instability causing possible injury.

Air Circulation Tip

When considering the location or position of your TV, we recommend you place it at least 2” (inches) away from the wall. Like most electrical equipment and appliances, better air circulation allows your television to run cooler, assuring a long, trouble-free life.

At Least 2” (Inches) Away from Wall

Terminal Cover

Side Panel for Input Terminal

Included in the accessories bag is the side panel to cover the input terminals, located on the bottom right of your TV. See diagram. Follow the steps below to attach or remove this side panel:

1.Remove the side panel from the accessories plastic bag attached to the back of your TV.

2.Route all of the cable downward so the cover can close over them.

3.Position the three tabs directly opposite the three slots (see diagram) and gently push toward the front of the TV.

4.Slide the two push tabs into the slots on the other side of the terminals until both tabs snap into place.

Result: The side panel neatly covers the input jacks.

Reverse these steps to remove the side panel from the input terminal.

Slots for Push Tabs

Side Panel

Tabs Push Tabs

Slots

Ventilation for Model WT-42315

71