Mitsubishi Electronics S490, X490, X500 user manual Using the remote control, Battery installation

Models: S490 X500 X490

1 36
Download 36 pages 63.59 Kb
Page 8
Image 8
Using the remote control

Using the remote control

Battery installation

Use two AA size batteries.

1.Remove the back cover of the remote control by pushing the battery compartment door in the direction of the arrow.

2.Load the batteries making sure that they are positioned correctly (+ to +, and - to -).

3.Replace the back cover.

1

2

3

Important:

Do not use a new battery with an old one.

Load batteries in the correct position.

Do not heat, take apart, or throw batteries into fire.

Do not try to recharge batteries. Do not use rechargeable batteries.

If the solution of batteries comes in contact with your skin or clothes, rinse with water. If the solution comes in contact with your eyes, rinse them with water and then consult your doctor.

Operation area (for wireless control system)

The range for operation is about 10 m (about 32 feet) when the remote control points to the projector. The dis- tance to the screen back to the projector must be less than 7 m (about 23 feet). Depending on the type of the screen, the distance will be different.

20˚

20˚

15˚

15˚

30˚

30˚

Important:

20˚

20˚

Avoid the direct sunlight or fluorescent light to the remote control sensor. Also keep the distance of more than 2 m between the remote control sensor and fluorescent lamp on the remote control may not work correctly.

Using the wired remote control

Attached remote control for this projector can be used as a wired remote control with remote control cable. Wired remote control is useful for operating in a distance or outside of the operating area.

 

INPUT SELECT

COMPUTER 1 IN

AUDIO 1 IN

RS-232C

USB

 

 

REMOTE

 

 

VIDEO 1 IN VIDEO 2 IN

 

DIGITAL

 

 

 

ANALOG

 

 

 

 

MAIN

COMPUTER 2 IN

AUDIO 2 IN

S-VIDEO

 

 

 

VIDEO

 

O

I

 

 

 

 

 

AC IN

COMPUTER OUT

AUDIO OUT

L

 

 

 

 

 

AUDIO

R

When the remote control is connected with remote control cable, it does not work as a wireless remote control.

When you need a longer cable, use a pin-pin cable.

When using the wired remote control, the laser beam may be darker. It is normal.

EN – 8

Page 8
Image 8
Mitsubishi Electronics S490 Using the remote control, Battery installation, Operation area for wireless control system