1. Basic Setup and Operation | 7 |
The STATUS Indicator
Key | Off | Steady On | |
| Slow Blinking | Fast Blinking | |
|
|
| |
LED Color | TV Condition |
| |
|
| ||
None | TV is powered off. Normal operation. | ||
|
| ||
|
| ||
Green | TV is powered on. Normal operation. | ||
|
| ||
|
| ||
Green | TV powered off, | ||
set. |
| ||
|
| ||
| Normal operation. TV can be turned on | ||
| at any time. |
| |
|
| ||
Green | TV just powered off and lamp is | ||
cooling. |
| ||
|
| ||
| Sixty seconds after turning off TV, LED | ||
| will start to blink. TV can be turned back | ||
| on before blinking starts or after blink- | ||
| ing stops, but not while the indicator is | ||
| blinking. Normal operation. | ||
|
| ||
Yellow | TV is too hot. The TV will display a | ||
warning message and shut off if it over- | |||
| |||
| heats. |
| |
| • Ambient room temperature may be | ||
| too high. Turn off the TV and let the | ||
| room temperature drop. | ||
| • Clear blocked air vents. Ensure at | ||
| least a | ||
| sides of the TV. |
| |
|
| ||
Yellow | Lamp access door is not secure or no | ||
lamp installed. |
| ||
|
| ||
| TV will not operate until lamp access | ||
| door is secured. See Appendix A. | ||
|
| ||
Red | Lamp failure. Replace the lamp. See | ||
Appendix A. |
| ||
|
| ||
|
| ||
Red/ | TV may require service. | ||
• Hold power button on front panel for | |||
Yellow | |||
| 10 seconds to reset TV. | ||
| • If LED continues to flash red and | ||
| yellow after reset, turn off the TV and | ||
| unplug it from the AC power source. | ||
| Wait one minute and then plug the | ||
| set back in. |
| |
| • If LED continues to flash red and | ||
| yellow, go to | ||
| or call | ||
| Authorized Service Center informa- | ||
| tion. |
| |
| You may be asked to count how | ||
| many times the LED flashes each | ||
| color to aid in troubleshooting. | ||
|
|
|
Setting Up and Using TV Inputs
Using the ANT (Antenna) Input
If using an antenna or direct cable service (no cable box), connect the incoming coaxial cable to the TV’s ANT input. Refer to page 12.
You must perform a channel scan to enable recep- tion of digital channels. If you skip this step, the TV will receive only analog channels. The channel scan will search for
Memorizing Channels with Channel Scan For the ANT input
To start channel memorization
1.Power on the TV.
2.Press MENU and open the Setup > Channel menu.
First press to navigate to the Setup icon, then use to highlight the Channel icon.
Start channel memorization from the Setup > Channel menu.
3.Press to enter the menu.
4.Highlight Ant Air if connected to an
5.For
6.Highlight Scan and press ENTER. Channel memorization may take up to 15 minutes to complete.
To stop channel memorization before completion, press CANCEL.
Downloaded From
For assistance call 1(800)