Moen 7025, 7034 Microtech Filter Installation/Replacement, To replace or install filter, INS215A

Filtering Appliance Faucet head o-ring seal

Spacer Outlet Ports

Filter

MICROTECH™ FILTER INSTALLATION/REPLACEMENT

1. Install a new filter by wetting the outlet ports with water and then inserting into the round filter ports on the faucet head and pushing the filter and head together. Both outlet ports must be

fully inserted into the filter ports. 2. Install the filter and faucet head

assembly on to the spout by wetting the faucet head o-ring seal and rubber spacer and

then carefully sliding the free end of the filter into the spout. The head will need to be initially turned approximately 1/2 turn counter clockwise from its normal position to slip past the safety catch. Lock the head into place by simultaneously pushing and twisting the head clockwise. When properly installed the head will feel secure, and will be correctly oriented on the spout.

3. Reset the filter life indicator by pushing the filter button 3 times. Wait 10 seconds. You should not be running water while resetting the filter life indicator because the filter button will remain depressed with the first push as it switches to filter mode. The filter life indicator

has been correctly reset if a short series of rapidly flashing green light occurs, indicating that the new filter flushing

period has begun. 4. Flush the filter (see page 3) for 5 minutes before

initial use.

Your new Moen faucet is now ready for normal use.

To replace or install filter -

1. Turn off the faucet. Remove the faucet head by twisting it approximately 1/4 turn counter clockwise to unlock it. Gently pull the faucet head away from the spout and twist it approximately another 1/4 turn to get

the faucet head past the safety catch. The faucet head and depleted filter (if one is installed) can now be pulled completely out of the spout.

2.The filter is held to the faucet head by two outlet

ports, which connect into the head. Remove the old filter by simply pulling it straight off. Discard the old filter

and install a new MicroTech 400 or 600 filter.

Note: The faucet will function correctly in unfiltered stream mode with or without a filter installed. The faucet will not function correctly in

filter mode without a filter. If a filter is not installed and the filter button is depressed, unfiltered water will flow from both the filtered water outlet and the stream outlet aerator, and the filter button will not automatically stay depressed.

Use only Microtech 400 or 600 filter cartridges with the PureTouch Classic Filtering Faucet system. The Microtech filters are high performance carbon block filters developed specifically for the PureTouch system.

INS215A	HELPLINE: 1-877-DRINK-H2O	8
	1-877-(374-6542)