Quick Reference 5
1. Peel mode only. Tear the backing paper just above the pinch roller.
2. Open the supply cover completely.
3. Spread the supply holder tabs apart and remove the supply roll.
4. Peel mode only. Carefully pull out the supply backing paper still in
place between the pinch and feed rollers.
Cleaning the Printer Do Not use sharp objects to clean the printer. Use isopropyl alcohol on the
interior areas only (except where specified), never on the exterior.
Cleaning the Printhead
1. Turn off the printer.
2. Open the supply cover and remove the
supplies.
3. Check the supply holder for adhesive
buildup, and clean it, if necessary.
4. Ground yourself by touching metal on
something other than the printer.
Grounding prevents electrostatic
discharge, which may cause damage.
5. Clean the printhead area of all adhesive and label particles using a
Monarch Cleaning Pen (#114226) or a soft cloth moistened with
isopropyl alcohol.
6. Reload the supply and close the cover.
Cleaning the Pinch and Feed Rollers
1. Turn off the printer and open the supply cover.
2. Remove the supplies.
3. Turn the platen roller with your fingers and run a dry, lint-free cloth
across the pinch and feed rollers as they turn. Make sure the rollers are
clean all the way around. If that does not work, use a cloth dampened
slightly with distilled water.
4. Clean any adhesive buildup you see as the rollers turn.
5. Reload the supplies after the printer dries.
Cleaning the Scanner Window
1. Moisten a soft cloth with water.
2. Wipe the window until it is clean.