Monessen Hearth DBX24C* Installing Rock Wool and Checking Burner Flame, Placing Rock Wool, Clean

INSTALLING ROCK WOOL AND CHECKING BURNER FLAME

PLACING ROCK WOOL

DFX24C AND DFX32C MODELS

After installing logs, pull apart dime-size pieces of rock wool. Sprinkle rock wool evenly over burner ports. Wash hands after installing rock wool. Itching may occur.

WARNING	• Use only rock wool provided with log set.
	• Do not add additional rock wool.
	• Place rock wool on burner ports only.
	• Keep air gap between rear log and burner
	CLEAN.

Dime Size

Rock Wool

Figure 40 - Rockwool Installation

(DFX24C and DFX32C)

CHECKING BURNER FLAME

DBX24C MODEL

In normal operation at full rate after 15 minutes, the following flame appearances should be observed:

The flames inside the one-piece log may be yellow. The flames should extend approximately 2" - 4" above the log. See Figure 41.

DFX24C AND DFX32C MODELS

In normal operation at full rate after 15 minutes, the following flame appearances should be observed:

Burner will have a random pattern of yellow flames. See Figures 42 and 43. There should be glowing embers in front of burner.

NOTE: The front flames and embers will be an opaque orange color during the burn off time.

One-piece

Log

Figure 41 - Correct Appearance of Flames

(DBX24C)

Figure 42 - Correct Appearance of Flames	Figure 43 - Correct Appearance of Flames
(DFX24C)	(DFX32C)

33D4047 27