Attaching the Vertical Adjustment Bars to the TV

DO NOT lay your TV face down when attaching the Vertical Adjustment Bars. This can cause permanent damage

to your screen. Lean it against a wall or other solid surface so it remains vertically upright.

Your TV should be unplugged before threading any bolt or screw into the back panel.

Your mounting system features 12 sets of screws of varying diameter

and length. Before attaching the adjustment bars to your display, determine which screw set is correct for your display.

TVs with flat backs use a shorter screw without a spacer. TVs with curved backs or recessed inserts may require a longer screw with a spacer between the TV and adjustment bars. Smaller M4, M5 or M6 screws require a square washer (supplied) between the adjustment bar and each screw.

1)Locate the threaded inserts on your TV’s back panel. Thread a screw from the set into one of the inserts to ensure it is the correct choice.

2)Thread screws through the adjustment bars into the TV inserts with the appropriate spacer and washer set, if needed.

3)With a Phillips screwdriver, tighten the screws so the adjustment bars are firmly attached to the TV.

DO NOT over tighten screws. Thread screws carefully by hand before tightening. If you feel any resistance, remove the screw immediately.

12

Page 16
Image 16
Monster Cable 200M warranty Attaching the Vertical Adjustment Bars to the TV