LIT_PRO7000_manual.qxd 11/10/2003 4:30 PM Page 31

Q. Will it damage a component if plugged into a PowerSource outlet that’s not designed for it, like putting a high-power amplifier into a Mixer/Preamplifier outlet?

A. No. However, as mentioned, you may not realize the full performance potential of the component.

Q. If my PowerSource stops operating, what should I do?

A. First check the reset button labeled BREAKER 15A on the rear panel of the PowerSource. It’s possible

an overload condition can be caused by high-powered audio equipment. If your amplifiers draw too much power, a special circuit breaker may be tripped. To restore operation, wait 10 minutes and press the reset button.

If power is still not restored, refer to page 24 and read through the related troubleshooting questions.

30

Page 37
Image 37
Monster Cable PRO7000 owner manual If my PowerSource stops operating, what should I do?