Monster Cable PRO7000 owner manual Outlet Programming

LIT_PRO7000_manual.qxd 11/10/2003 4:30 PM Page 8

Step 2 Outlet Programming

All PowerSource outlets on the rear panel are programmable. To set up each outlet pair, use the front panel MENU and SET buttons to choose between SWITCHED ON, SWITCHED ON AFTER DELAY and UNSWITCHED (Always On) independently for each outlet pair. You can change the settings, whenever you like. Using the outlet pair labeled ANALOG FILTER as an example, the following diagrams illustrate how it’s done:

A)Power up the PowerSource: Press the ON/OFF switch one time to power the unit and start the process. Once the PowerSource is on, the display will show the AC line voltage as in figure 2.

Note: The power-on process may take up to 60 seconds since any outlet pair can be configured as SWITCHED ON AFTER DELAY. You can see any outlet pair’s power status LED on the front panel (refer to page 18)

B)Set Outlet Pair to SWITCHED ON: Press MENU until the second line display shows the status

of the ANALOG outlet pair. Press the SET button until the time delay changes to 0 (zero), as in figure 3.

The 0 (zero) time delay setting indicates SWITCHED ON mode for the ANALOG outlet pair. This pair will be live once the PowerSource is powered up by pressing the front panel ON/OFF button, or triggered by an external signal.

7