Monster Cable PRO7000 owner manual Remote DC Control Hookup

LIT_PRO7000_manual.qxd 11/10/2003 4:30 PM Page 13

Step 6 Remote DC Control Hookup

This feature allows your PowerSource to be turned on and off with an Automatic Switching Control. A component that shouldn’t be powered on constantly (such as an amplifier) can be plugged into one of the SWITCHED ON AFTER DELAY outlets and activated when needed. This feature also allows

the DC low-voltage cable to control multiple PowerSources.

A)Plug a 1/8“ mini-plug cable into the REMOTE IN DC 3 - 30V outlet on the PowerSource (see diagram below).

B)Plug the other end of the cable into the corresponding outlet on a component with a 12V trigger output. When powered up, the PowerSource’s outlets programmed as SWITCHED ON will power on immediately. The outlets programmed as SWITCHED ON AFTER DELAY will power on after the set delay.

	Analog Filter	1 Digital Filter 2	Computer Filter	1 High Power	2
				Filter		XLR LAMP
						DIMMER
						DC IN
						3-30V
						GROUND
XLR LAMP						XLR LAMP
						AC IN
						120V
						BREAKER 15A
MAX OUTPUT						MAX OUTPUT
12 VDC 3W						12 VDC 3W
						DC OUT
						12V
						AC 120V
						60Hz
						1440W CONTINUOUS
				NORMAL	BALANCED	(1800W MAX)
						PHONE
				(ISOLATED)
				NOISE REDUCTION
PRO7000				MODE
Professional Reference PowerSource™	ANALOG FILTER FUSE	DIGITAL FILTER FUSE	COMPUTER FILTER FUSE
with Dual Balanced Pure Power™	2A SB NO. 1	2A SB NO. 1	10A SB NO. 1		IN	OUT

Illustration of rear panel showing remote in DC 3-30V

12