Morphy Richards Cordless hand blender manual Assembling the blender, To disassemble hand blender

48965 Rev 1 13/4/04 3:47 PM Page 5

Assembling the blender

1Once the blender is charged, fit the blender leg by attaching it into the

location slot on the blender body. C Press until it clicks into place.

•If the leg is not fully engaged, rotate it round and try again.

WARNING: Do not touch the blade

or hold the blender leg at this end when fitting to the body.

WARNING: To remove the blender leg, hold blender in a position so you cannot press the operating button, grip shaft of blender leg, press the release button and pull apart.

To disassemble hand blender

1To remove the blender leg, hold the blender in a position so that you cannot press the operating button. Grip shaft of blender leg, press the release button and

pull apart. D

WARNING: When the blender is not in use, fit the blade cover to the leg for safety.

C

Using the blender

1To operate press the on/off button and begin to blend. E

•For perfect blending use a ‘plunging action’ this will allow the food to be pulled into the blade and dispersed through the exit vents.

•Keep the head of the blender beneath the food surface to prevent splashing.

•The hand blender can be used with a beaker or a bowl.

WARNING: Never use your appliance

in a hot saucepan transfer to a bowl, allow to cool before blending.

IMPORTANT: Your hand blender is designed for intermittent use only. Do not use non-stop for more than 1 minute. Allow to cool down for a minimum of 5 minutes before further use.

D

E

5