70515+70516 Rev 1 19/5/04 3:59 PM Page 5
To fit the connector
1Push the connector end, holding it
upside down, fully into the brush inlet E.
2Twist the connector 1/2 a turn, until it is in place. F
•The fit between the connector and the tubes and/or handle is tight to ensure no steam leaks. It is recommended to keep both parts lubricated to facilitate connecting and disconnecting.
3To detach the accessories, press the release button È and pull the items apart.
WARNING: Accessory heads may be
hot. Please be careful not to trap your fingers.
•The triangular nozzle also has a cotton sock which fits over the bristles. Ideal for use on upholstery and bedding.
Operating your steam cleaner
1Connect the unit to the mains and switch on the boiler heater by pressing the heater on/off button ¤. The ‘heater on light’ is illuminated.
E
F
•Steam will be available in approx 10 mins. When the steam is ready for use the ‘steam ready’ light fl will turn green.
2Make sure that the locking mechanism
Áon the handle has been released. If you push the lock Á towards the rear, the steam switch cannot be operated.
Push the lock forward so that the steam switch is released. G
3To make steam ready, press the ‘steam on/off’ button ‹ and the orange light · will come on. Steam is now ready to be released.
4To release steam, press the handle
control switch Ê. At the start, always point the steam handle at a cloth until a steady flow of steam comes out.
•During steam release the green heater light will turn off.
5To stop releasing steam, simply release the handle control switch Ê.
Certain models only
•If your cleaner features a
6Turn the
clockwise for maximum steam and clockwise for minimum steam flow H.
•If the ‘refill’ indicator light ‡ turns red, the boiler must be refilled.
| G | Á | Ê |
|
| ||
|
|
|
Â
H
Í
5
