Morphy Richards GrimeBuster steam cleaner Re-filling, Switching the unit off, Use of accessories

70515+70516 Rev 1 19/5/04 3:59 PM Page 6

Re-filling

When the ‘refill’ light ‡ turns red, there should be no steam available for release. The boiler needs to be refilled.

1Switch off the boiler heater by pressing the heater on/off button ¤.

2If there is pressure in the boiler, the filler cap ⁄ will revolve, a safety feature prevents it from being unscrewed.

3Release any steam pressure in the system using the steam on/off switch ‹ on the machine and handle Ê. Switch off the steam release button ‹. The cap

can then be unscrewed.

4Unplug the mains cable. Leave the product with the filler cap off for 10 minutes before refilling.

5Refill the boiler using the funnel A.

6Use warm water to reduce heat-up time.

WARNING: Do not pour cold water

into a very hot boiler as steam and hot water may be blown out of the filling hole and can scald.

7Screw the cap back on. Start operation again. (See operation section).

Switching the unit off

1Switch the unit off by means of switches ¤ and ‹.

2Remove the hose plug ‰ from the unit by pressing the release button, holding

down the socket flap simultaneously.

3Remove the plug from the mains socket.

4 Any remaining water can be left inside the unit.

• To avoid deforming the brushes  and

Òensure that the brushes are allowed to cool down before storing.

I

Use of accessories

Steam handle Â

To avoid spurting of heavy and moist steam it is recommended always to attach an accessory to the steam handle.

Large floor brush Ì Recommended applications include:

-carpets and rugs

-sealed timber and parquetry

-ceramic tiles

-vinyl

1The large floor brush can be attached to the extension tubes or directly to the steam handle, provided that the brush connector Ó is fitted.

2Stretch the cotton cloth lightly over the bristles using the clips provided on the brush head I.

3Switch on the steam and move the cloth

covered brush gently over the surfaces to be cleaned.

•Replace the cloth regularly so that more dirt can be collected and to avoid too much moisture being applied to the floor and leaving it very wet.

•Heavily soiled areas will require more attention to allow steam more time to act on dirt while lightly soiled and smooth surfaces will only require a quick wipe.

Jet nozzle Ô and round brush  and Ò Recommended applications include

-Hard to reach surfaces such as corners and joints.

-Toilets and sanitary installations

-Venetian blinds

Without round brush

-Defrosting freezers

-Eliminating odours and creases in clothing. Firstly place the garment on to a clothes hanger and spray steam at a distance of around 10-15cm.

-Removing dust from plants. Maintain a distance of around 30-40cm to avoid burning leaves by direct contact with steam.

6