2.Press and hold pto switch ON the parent unit. The power LED will light up in green.

3.Press and hold pto switch OFF the parent unit.

NOTE

Once the baby and parent units are switched on, the display on the parent unit will show the video captured by the baby unit. When the VOX mode is on, the screen will turn off after a few seconds if the sound near the baby unit drops below the Voice Activation threshold level of the unit.

When there is no connection or out of range, the icon on the LCD display will flash and the parent unit will beep continuously. Move the parent unit closer to the baby unit until the link is re-established.

2.5Registration

The Baby monitor is pre-registered to your Parent Unit. You do not need to register it again unless the Baby Unit loses its link with the Parent Unit.

To re-register your Baby Unit, or register a new Baby Unit, follow the procedure below:

1.Switch off the Baby Unit

2.Press and hold the mbutton on the Parent Unit until appears on the display screen.

3.Then press the mbutton to confirm the selection and enter the

registration mode. ..... will appear on the screen for up to 15 seconds.

4.Switch the Baby Unit ON to enter the registration mode. The power LED on the Baby Unit flashes quickly for approximately 3 seconds.

The registration is completed when .....OK appears and then the

video captured by Baby Unit’s camera appears on the display screen of the Parent Unit.

If the registration fails then .....X appears and then both the Parent

and Baby Unit return to normal mode.

NOTE

If a particular Baby Unit had been registered already, registering this current Baby Unit again will over-write the old registration.

10

Getting started

 

 

Page 10
Image 10
Motorola MBP35BL manual Registration