Motorola ME4050 manual Connecting the Base Station and Mains Adaptor

Do not expose the base station and charger unit to direct sunlight. Do not allow the base station and charger unit to become wet. They should not be set up in rooms which are subject to condensation or corrosive steam or a high concentration of dust (e.g. cellars, garages or conservatories). The room temperature must be between 00C and 350C.

Connecting the Base Station and Mains Adaptor

Insert the plug in the corresponding socket of the base station (it is not possible to mix them up as the socket and plug are designed to be reverse-polarity protected). Route the cable beneath the telephone towards the back. Insert the plug into the socket of the telephone plug of your telephone connection. Insert the mains adaptor in the wall socket. The base station is now ready for use.

The base station does not have a power switch. Make sure that there is a mains socket nearby and that the mains adaptor is easily accessible. Check that the voltage indicated on the mains adaptor corresponds to that of your mains current.

Installation

9

Installation

Open the battery compartment, by pushing downwards on the cover. Insert the 2 x AAA (600mAh/1.2V) Ni-MH re-chargeable batteries supplied, observing the correct polarity.

CAUTION : PLEASE DO NOT USE ALKALINE OR NON- RECHARGEABLE BATTERIES. IT MAY CAUSE PERMANENT DAMAGE TO THE

UNIT AND VOID THE WARRANTY.

10