Motorola ML910TM specs

9.Click on the Close button when ML Administrator Application is successfully installed.

9.Click on the Close button when ML Administrator Application is successfully installed.

10.The upgrade procedure is complete. Restart the system in BIOS Setup mode if you wish to reset the Boot Device Priority Sequence. Also, restore any security or policy configurations that may have been disabled in order to perform this upgrade.

11.Proceed to the next section (IV. Enabling the RF Pass-Through Option Using MLAA and MLUA) when you are ready to enable and configure this feature.

18	ML910 R1.0 RF Pass-through Upgrade Procedure, Version A

Image 18

Motorola ML910TM manual ML910 R1.0 RF Pass-through Upgrade Procedure, Version A

Contents

What You Will Need ML910 R1.0 RF Pass-through Upgrade Procedure, Version APurpose and Requirements 2 Support RF Pass-through in Retrofitted ML900 Docking Stations ML910 R1.0 RF Pass-through Upgrade Procedure, Version A Step-by-Step Procedure ML910 R1.0 RF Pass-through Upgrade Procedure, Version ATo determine the EC BIOS version I. EC BIOS Upgrade Procedure Perform Procedures I, II and III in order 5. Click on “Image, Project, Copy” 6. Click on “Disc Image or Saved Project” 9. Burning process and status are displayed ML910 R1.0 RF Pass-through Upgrade Procedure, Version A II. ML User Application Upgrade Procedure a. MLSERVICE foldera. Click Start Control Panel Add or Remove Programs 5. Click Yes to install Microsoft Visual C++ 2005 Runtime Libraries 6. Double-click on SETUP.EXE in the MLSERVICE folder7. Click the Next button to continue 8. Accept the default settings and click the Next button 9. Click the Next button to start the installation10. Please wait while MLService is being installed ML910 R1.0 RF Pass-through Upgrade Procedure, Version A 12. Double-click on SETUP.EXE in the MLUA folder 14. Accept the default settings and click the Next button13. Click the Next button to continue 15. Click the Next button to start the installation 16. Please wait while ML User Application is being installed 17. Click on the Close button when ML User Application is successfully installed III. ML Administrator Application Upgrade Procedure 2. Uninstall the existing version of the ML Administrator Applicationb. Select ML Administrator Application and click Remove to uninstall 4. Double-click on setup.exe 5. Click the Next button to continue 6. Accept the default settings and click the Next button 7. Click the Next button to start the installation 8. Please wait while ML Administrator Application is being installed 9. Click on the Close button when ML Administrator Application is successfully installed IV. Enabling the RF Pass-Through Option Using MLAA and MLUA 5. Launch the ML User Application 11. Note that the RF Pass-Through Option will not be applicable under the following conditions