Motorola MS4404, MS4407 Simple Serial Interface Default Parameters

8 - 8 Symbol MS4404/MS4407 Integration Guide
Simple Serial Interface Default Parameters
This section describes how to set up the decoder with a SSI host. When SSI is used, the decoder is programmed
via bar code menu or SSI hosts commands.
Throughout the programming bar code menus, default values are indicated with asterisks (*).
Table 8-3 lists the defaults for the SSI host. There are two ways to change the default values:
• Scan the appropriate bar codes in this guide. These new values replace the standard default values in
memory. To recall the default parameter values, scan the *Set All Defaults bar code on page 6-3.
• Download data through the device’s serial port using SSI. Hexadecimal parameter numbers are shown in this
chapter below the parameter title, and options are shown in parenthesis beneath the accompanying bar
codes. See the Simple Serial Interface (SSI) Programmer’s Guide for detailed instructions for changing
parameters using this method.
*Baud Rate 9600
(06h) Feature/Option
* Indicates Default
Option Hex Value for programming
via SSI command
NOTE Most computer monitors allow scanning the bar codes directly on the screen. When scanning from the
screen, be sure to set the document magnification to a level where the bar code can be seen clearly, and
bars and/or spaces are not merging.
NOTE See Appendix A, Standard Defaults for all user preferences, hosts, symbologies, and miscellaneous
default parameters.
Table 8-3 SSI Default Table
Parameter Parameter
Number Default Page Number
Select SSI Host N/A N/A 8-10
Baud Rate 9Ch 9600 8-11
Parity 9Eh None 8-13
Check Parity 97h Disable 8-14
Software Handshaking 9Fh ACK/NAK 8-14
Host RTS Line State 9Ah Low 8-15
Decode Data Packet Format EEh Send Raw Decode Data 8-15
Stop Bi ts 9Dh 1 8-16