Chapter 12 Miscellaneous Imager Options

Introduction

This chapter includes commonly used bar codes to customize how data is transmitted to the host device.
The imager ships with the settings shown in the Miscellaneous Imager Options Default Table on page 12-2 (also
see Appendix A, Standard Defaults for all host device and miscellaneous imager defaults). If the default values suit
requirements, programming is not necessary.
There are two ways to change a parameter value:
•
Capture the appropriate bar codes in this guide. These new values replace the standard default values in
memory.
•
For SSI and USB SNAPI hosts, send a “parameter send” command from the host system. Hexadecimal
parameter numbers are shown in this chapter below the parameter title, and options are shown in
parenthesis beneath the accompanying bar codes. See the Simple Serial Interface (SSI) Programmer Guide
for detailed instructions for changing parameter values using this method.
To return all features to default values, capture *Set All Defaults on page 6-3. Throughout the programming bar
code menus, default values are indicated with asterisks (*).
Imaging Sequence Examples
In most cases, capture one bar code to set a specific parameter value. Other parameters, such as Prefix Value,
require capturing several bar codes. See each parameter for descriptions of this procedure.
NOTE Most computer monitors allow capturing the bar codes directly on the screen. When capturing from the
screen, be sure to set the document magnification to a level where the bar code can be seen clearly, and
bars and/or spaces are not merging.
*Disable No Read
(00h) Feature/Option
* Indicates Default
Hex Value