Chapter 11 Symbologies
Overview
This chapter describes symbology features and provides the programming bar codes for selecting these features.
Before programming, follow the instructions in Chapter 1, Getting Started.
The imager is shipped with the settings shown in the Symbology Default Table on page 11-2 (also see Appendix A,
Standard Defaults for all host device and miscellaneous defaults). If the default values suit requirements,
programming is not necessary.
There are two ways to change a parameter value:
•
Capture the appropriate bar codes in this guide. These new values replace the standard default values in
memory.
•
For SSI and USB SNAPI hosts, send a “parameter send” command from the host system. Hexadecimal
parameter numbers are shown in this chapter below the parameter title, and options are shown in
parenthesis beneath the accompanying bar codes. See the Simple Serial Interface (SSI) Programmer Guide
for detailed instructions for changing parameter values using this method.
To return all features to default values, capture *Set All Defaults on page 6-3. Throughout the programming bar
code menus, default values are indicated with asterisks (*).
NOTE Most computer monitors allow capturing the bar codes directly on the screen. When capturing from the
screen, be sure to set the document magnification to a level where the bar code can be seen clearly, and
bars and/or spaces are not merging.
*Enable UPC-A
(00h) Feature/Option
* Indicates Default