Hardware Preparation and Installation
2 | Installation Instructions |
| |
| The following sections discuss the installation of the MVME166 in a VME |
| |
| chassis, and describe system considerations relevant to the installation. |
| Ensure that an EPROM device is installed as needed. The factory |
| configuration provides for one EPROM (installed for 166BBug, the BootBug |
| firmware subset of the MVME166Bug debug monitor contained in Flash |
| memory) in socket U12. Ensure that all header jumpers are configured as |
| desired. |
| MVME166 Module Installation |
| Now that the MVME166 module is ready for installation, proceed as follows: |
a.Turn all equipment power OFF and disconnect power cable from ac power source.
Caution
!
WARNING
Inserting or removing modules while power is applied could result in damage to module components.
DANGEROUS VOLTAGES, CAPABLE OF CAUSING DEATH, ARE PRESENT IN THIS EQUIPMENT. USE EXTREME CAUTION WHEN HANDLING, TESTING, AND ADJUSTING.
b.Remove chassis cover as instructed in the equipment user’s manual.
c.Remove the filler panel(s) from the appropriate card slot(s) at the front and (if the chassis has a rear card cage that you intend to use) rear of the chassis.
The MVME166 module requires power from both P1 and P2. It may be installed in any
MVME166 Single Board Computer Installation Guide |