Motorola PTP 600 Series 7 Installation

7 Installation

Motorola recommends that only qualified personnel undertake the installation of a PTP 600

Series Bridge solution.

Before proceeding with the installation you should:

• Check the contents of all packages against the parts lists shown in the packing list.

• Ensure that you have the correct tools for the job.

• Ensure that you are qualified to undertake the work.

• Ensure that you have taken the correct safety precautions.

• Have completed the site planning as described in section 6 “Site Planning”.

The 600 Series installation procedure consists of the following steps:

• Mounting the ODUs, section 7.6

• Connecting up, section 7.7

• Mounting the PIDU Plus units, section 7.7.8

• Powering Up, section

7.7.10

• Aligning the ODUs, section 7.7.11

The following specific tools are required to install a PTP 600 Series Bridge in addition to

general tools:

• 13mm Spanner / Wrench

• RJ45 Crimp Tool

• IBM Compatible Personal Computer (PC) running Windows 98 or later with 10, 100 or

1000 BaseT Ethernet (Ability to change IP settings easily is recommended)

• Either Internet Explorer version 6 or higher, or FireFox 1.5 or higher are recommended.

• Ethernet patch cable

• 6mm general purpose crimp tool for the grounding lug (optional for Lightning Protection)