Motorola SB4100 manual Cabling For a Single User, Usb

SURFboard R

Introduction Before You Begin Installation Operation Basic Configuration Troubleshooting

Cabling For a Single User

To

Ethernet or

USB

To

cable outlet

To

electrical

outlet

1 Connect the coaxial TV cable to the SB4100 connector marked CABLE and the other end to the cable outlet or splitter. Hand-tighten the connectors to avoid damaging them.

You may need a 5-900 MHz splitter and an additional length of 75-ohm coaxial cable if you have a TV connected to the cable outlet.

2 Plug the power cord into the SB4100 connector marked POWER and the other end to the electrical outlet.

CAUTION !

Do not connect both Ethernet and

USB cables to the same computer.

3 Connect your computer to the SB4100 using one of the following methods:

Ethernet

Connect the 10/100Base-T shielded Ethernet cable to the SB4100 Ethernet connector and the other end to the Ethernet jack

on the back of your computer.

or

USB

Connect the USB cable to the SB4100 port marked USB and the other end to the USB port on the back of your computer.

TM

7