Modbus Settings
Setting | Value |
| Notes | |
| Modbus RTU Slave1 |
| Set the Modbus type of the | |
| Modbus ASCII Slave | 2 | ||
Attached Serial Device type |
| serial device attached to | ||
Modbus RTU Master3 | ||||
| NPort 6110’s serial port. | |||
| Modbus ASCII Master4 |
| ||
|
|
| NPort Modbus Gateway | |
| 100 to 3276 ms; |
| provides this setting for | |
Initial delay time |
| those PLCs that need a | ||
default = 100 ms |
| |||
|
| longer time for their | ||
|
|
| ||
|
|
| system to be initialized. | |
Modbus/TCP Slave device setting |
|
| ||
| IP address assigned to | Valid when the attached | ||
Remote Modbus Slave IP | the remote Modbus |
| serial device is a Modbus | |
| slave device. |
| RTU/ASCII Master. | |
| default = 502 |
| Set this value to 0 (zero) to | |
TCP Port No. |
| disable the corresponding | ||
|
|
| Modbus/TCP slave device. | |
| 1 to 247 |
| The unique Modbus ID | |
ID No. Range |
| number assigned to the | ||
|
|
| Modbus device.5 | |
Additional Information
1.When the serial Modbus device is running in Modbus/RTU Slave mode, the NPort Modbus Gateway is ready to connect automatically to Modbus/TCP Master devices. Up to 7 Modbus/TCP master devices can connect to one serial Modbus slave device.
2.Modbus ASCII Slave mode works the same as Modbus/RTU slave mode, except that the data format is Modbus/ASCII.
3.When the serial Modbus device is running in Modbus/RTU Master mode, the NPort Modbus Gateway is ready to connect automatically to Modbus/TCP slave devices. You will also need to configure the IP address for up to 4 Modbus/TCP slave devices that can be connected to over the Ethernet network.
