Mr. Coffee BVMC-KG5 To de-scale the reservoir, To de-scale the Brewer, Problem, Solution

To de-scale the reservoir:

1.Make sure that the Brewer is unplugged.

2.Fill the reservoir with fresh, undiluted white household vinegar.

3.Allow appliance to sit overnight with the vinegar solution in the water reservoir.

4.Discard vinegar by removing the reservoir lid and turning reservoir upside down over the sink.

5.Rinse the water reservoir thoroughly with tap water by filling reservoir half full with water and then pouring the water back out into the sink, repeating this step twice.

To de-scale the Brewer:

Step 1: Make sure you have at least 8 ounces of undiluted white vinegar on hand. You will also need a 10 oz ceramic mug (do not use a paper cup) and access to a sink.

Step 2: Fill reservoir with 8 ounces of undiluted white vinegar, place a ceramic mug on the Drip Tray Plate.

Step 3: Close the brew head and perform a brew into the ceramic mug without adding a K-Cup®Portion Pack.

Step 4: Start a brew but power off the Brewer just after it starts to dispense and then allow it to sit for at least 30 minutes.

Step 5: After the prescribed period of time, perform a brew without adding a K-Cup®Portion Pack. Empty the contents of the ceramic mug into the sink, be careful as contents may be hot.

Step 6: Fill the reservoir with 8 ounces of bottled water, close the brew head, place a cup on the Drip Tray Plate and perform a brew.

Step 7: Repeat Step 6 three times using bottled water (with no K-Cup®Portion Pack in place) to clean the Brewer plumbing and get rid of any residual taste from the vinegar. The Brewer is now ready for normal use again.

14

TROUBLESHOOTING YOUR SINGLE SERVE BREWER

Beyond these recommended cleaning and maintenance procedures this Brewer is not user serviceable, for service please refer to the Warranty section in this guide.

PROBLEM	SOLUTION
Brewer does not	Make sure the Power Button is pressed
have power	and is illuminated.
	Plug Brewer into an independent outlet.
	Check to be sure that it is plugged in
	securely.
	Plug into a different outlet.
Brewer will not	If Brewer is cold/frozen, wait for at
brew when used	least two hours for it to reach room
for the first time	temperature before powering on.
Brewer will not	Check to make sure there is water in the
brew	reservoir and the brew head is closed
	securely. NOTE: the Brew Now Button
	will flash if the brew head is open.
Brewing a partial	The Exit Needle may be clogged (refer
cup	to page 12).
	Clean K-Cup®portion pack Holder if
	necessary and rinse under faucet (refer
	to page 12).
	Make sure there is enough water in the
	reservoir to brew the selected serving
	size. NOTE: Serving size indicator lights
	will flash if the reservoir is not in place
	or does not have enough water to brew
	the selected serving size.
	15

BVMC-KG5_11ESM1.indd 15-16

11/11/11 4:00 PM