Mr. Coffee SPR-101006 manual Setting the Clock and Delay Brew Time, To Set the Clock

LM SERIES IB-FINAL:Layout 2 10/13/2009 12:05 AM Page 8

–Delay Brew – Would you like to wake up to a fresh pot of coffee? The timer allows you to preset when you would like the coffeemaker to automatically begin brewing your coffee, up to 24 hours in advance.

–Special Cleaning Cycle – Enables you to easily maintain and clean mineral deposits from your coffeemaker.

NOTE: If you have selected any of the operating functions, the coffeemaker will act upon the last operation selected if the power is restored within 10 seconds after a power outage.

CLEAN YOUR COFFEEMAKER BEFORE USING THE FIRST TIME

Make sure your first cup of coffee is as good as can be by cleaning your MR. COFFEE® Coffeemaker before its first use. Just follow these simple steps:

1.Wash the decanter, decanter lid and the filter basket in a mixture of mild detergent and water. Rinse each thoroughly (please refer to the parts diagram listed above).

2.Replace all the parts and close the lid. Then, run a brew cycle with water only, without adding coffee and coffee filter.

3.When brewing is complete, turn your coffeemaker off, discard the water in the decanter and rinse the decanter, decanter lid, and filter basket.

Your coffeemaker is now ready to use. Enjoy it!

SETTING THE CLOCK AND DELAY BREW TIME

To Set the Clock:

1 . Plug the power cord into a standard electrical outlet . The clock will flash on the control panel to indicate that the time has not been set yet .

2 . Press and hold the HOUR and MINUTE buttons until you reach the current time . The AM or PM indicator will light at the bottom of the display (Figures 1 and 2) .

The clock is now set!

NOTE: Pressing any button before setting the clock will cause the clock to start keeping time from 6:00 a . m . You must set the clock if you want to use the Delay Brew feature .

To Set the Delay Brew Time:

While the display is in the clock mode, simply press the SET DELAY button (Figure 3) and, while the DELAY BREW time is flashing, set the brew time by pressing the HOUR and MINUTE buttons . The AM or PM indicator will light at the bottom of the clock display . (Figure 4)

Within a few seconds the display will change to the current time .

The Delay Brew Time is now set!

NOTE: To activate the DELAY BREW cycle, see the “Brewing Coffee Later” section .

To check the programmed time, push the SET DELAY button . The display will show the time you have programmed the coffee to brew . If you press the SET DELAY button again or wait a few seconds, the display will switch back .

FIGURE 1

FIGURE 2

FIGURE 3

FIGURE 4

8 9