D-Link DES-3250TG Standalone Layer 2 Switch

The following fields can be set:

Parameter

Description

Spanning Tree

This field can be toggled between Enabled

Protocol <Disabled>

and Disabled using the pull-down menu. This

 

will enable or disable the Spanning Tree

 

Protocol (STP), globally, for the switch.

Bridge Max Age (6-40

The Bridge Maximum Age can be set from 6

Sec) <20 >

to 40 seconds. At the end of the Max. Age, if

 

a BPDU has still not been received from the

 

Root Bridge, your switch will start sending

 

its own BPDU to all other switches for

 

permission to become the Root Bridge. If it

 

turns out that your switch has the lowest

 

Bridge Identifier, it will become the Root

 

Bridge.

Bridge Hello Time (1-

The Bridge Hello Time can be set from 1 to

10 Sec) < 2 >

10 seconds. This is the interval between two

 

transmissions of BPDU packets sent by the

 

Root Bridge to tell all other switches that it is

 

indeed the Root Bridge.

Bridge Forward Delay

The Bridge Forward Delay can be from 4 to

(4-30 sec) <15 >

30 seconds. This is the time any port on the

 

switch spends in the listening state while

 

moving from the blocking state to the

 

forwarding state.

Bridge Priority (0-

A Bridge Priority for the switch can be set

65535 Sec) <32768>

from 0 to 65535. This number is used in the

 

voting process between switches on the

 

network to determine which switch will be

 

the root switch. A low number indicates a

 

high priority, and a high probability that this

 

switch will be elected as the root switch.

STP Version

Choose rstp or StpCompatibility. Both

 

versions use STP parameters in the same

 

way. RSTP is fully compatible with IEEE

 

802.1d STP and will function with legacy

 

equipment.

TX Hold Count(1-10)

This is the maximum number of Hello

 

packets transmitted per interval. The count

 

can be specified from 1 to 10. The default

 

value is 3.

Forwarding BPDU

This allows you to control whether or not to

<Enabled>

forward Bridge Protocol Data Units.

 

Disabling this setting can be useful if, for

 

example, the present switch has been

 

designated as the root bridge and you do not

 

want that status to change.

Note: The Hello Time cannot be longer than the Max. Age. Otherwise, a configuration error will occur.

49

Page 59
Image 59
D-Link DES-3250TG Spanning Tree, Protocol Disabled, Bridge Max Age, Bridge Hello Time, 10 Sec, Bridge Forward Delay