D-Link DES-3250TG Standalone Layer 2 Switch

 

(urgent), ack (acknowledgement),

psh

 

(push), rst (reset), syn (synchronize), fin

 

(finish).

 

 

 

src port mask - Specify a TCP port

 

mask for the source port in hex form (hex

 

0x0-0xffff), which you wish to filter.

 

 

dest port mask - Specify a TCP port

 

mask for the destination port in hex form

 

(hex 0x0-0xffff) which you wish to filter.

 

Select UDP to use the UDP port number

 

contained in an incoming packet as the

 

forwarding

criterion. Selecting

UDP

 

requires that you specify a source port

 

mask and/or a destination port mask.

 

src port mask - Specify a TCP port

 

mask for the source port in hex form (hex

 

0x0-0xffff).

 

 

 

dest port mask - Specify a TCP port

 

mask for the destination port in hex form

 

(hex 0x0-0xffff).

 

 

protocol id - Enter a value defining the

 

protocol ID in the packet header to mask.

 

Specify the protocol ID mask in hex form

 

(hex 0x0-0xffffffff).

 

Port

The user

may set the Access Profile

 

Table on a per-port basis by entering an

 

entry in this field. Entering all will denote

all ports on the Switch. The port list is specified by listing the lowest switch number and the beginning port number on that switch, separated by a colon. Then the highest switch number, and the highest port number of the range (also separated by a colon) are specified. The beginning and end of the port list range are separated by a dash. For example, 1:3 specifies switch number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3 - 2:4 specifies all of the ports between switch 1, port 3 and switch 2, port 4 in numerical order.

Packet Content Mask

The page shown below is the Packet Content Mask configuration window.

85

Page 95
Image 95
D-Link DES-3250TG manual Packet Content Mask, Psh