MRV Communications EM316E3SF manual Features, Requirements for Managed Module, Connectivity

Fiber Driver

EM316E3 & EM316E3SF

Features

•E3 conversion between coax media and fiber media

•Supports ITU-T G.703, ITU-T G.823, and HDB3 standards

•Supports Local, Remote and Line Loop back Test

•Up to 100km Transmission on Single Mode or 7km on Multimode Fiber

•Modules can be Inserted / Removed without powering off the chassis

•Extensive Network Management Support when used with EM316NM

*For dB budget see: ftp://ftp.fiberdriver.com/pub/doc/spec/fiberdriver

Requirements for Managed Module

EM316NM Management Firmware version 4.0 or later

For firmware released version go to: ftp://ftp.fiberdriver.com/pub/software/em316nm

For firmware beta version go to: ftp://ftp.fiberdriver.com/pub/software/beta/em316nm

MegaVision Network Management version 1.20 or later

Connectivity

Connectors Used

Coax: 75 Ω BNC (2 connectors: 1 for TX, 1 for RX)

Fiber: SC, or SC-APC (for single fiber)

Cable Requirement

Coax: RG58/U (Max Length=900 feet)

Fiber: SC-SC fiber cable, or SC-APC fiber cable (for single fiber)

Port Description

Port# Port Description

Port 1 E3 Coax, Conforms to ITU-T G.703, ITU-T G.823, and HDB3 standards Port 2 E3 Fiber, Multi-Mode: 1310nm, 0-2km

	Multi-Mode: 1310nm, 2-7km
	Single Mode: 1310nm, 0-25km
	Single Mode: 1310nm,	25-50km
	Single Mode: 1550nm,	50-100km
P/N: 1226006-001, REV_L		PAGE 6