3.Finish securing chute control assembly to chute support bracket with wing nut and hex screw removed earlier. See Figure 3-14.

Figure 3-14

4.Insert the chute directional control rod into the support bracket on the rear of the dash panel. See Figure 3-15.

Figure 3-15

5.Remove the hairpin clip from the rear of the chute control assembly.

6.Insert chute directional control rod into rear of the chute control assembly. Secure the chute directional control rod to the chute control assembly with the hairpin clip removed earlier. See Figure 3-16.

2

1

Figure 3-16

Standard Crank Assembly

Handle

1.Place the shift lever in the forward-6 position (if equipped).

2.Observe the lower rear area of the snow thrower to be sure both cables are aligned with roller guides before pivoting the handle upward. See Figure 3-17.

Figure 3-17

12Section 3— Assembly & Set-Up