2-Way & 4-Way Assembly

Remove all loose parts before assembling.

Handle Assembly

1.Place the shift lever in the Forward-6 position

2.Observe the lower rear area of the snow thrower to be sure both cables are aligned with roller guides before pivoting the handle upward. Pivot the handle upward. See Figure 3-1.

NOTE: Make certain the cables are seated properly in the roller guides. See Figure 3-2.

Figure 3-2

3.Secure the handle by tightening the plastic knob located on both the left and right sides of the handle. Remove and discard any rubber bands, if present. They are for packaging purposes only.

Figure 3-1

8Section 3— Assembly & Set-Up