NOTE: Make certain the cables are seated properly in the roller guides. See Figure 3-18.

Figure 3-18

2.Secure the handle by tightening the plastic knob located on both the left and right sides of the handle. Remove and discard any rubber bands, if present. They are for packaging purposes only.

Chute Assembly

1.Position the chute assembly over the base. See Figure 3-19.

Figure 3-19

2.Close the flange keepers to secure the chute assembly to the chute base. The flange keepers will click into place when properly secure. See Figure 3-20.

Figure 3-20

NOTE: If the flange keepers will not easily click into place, use the palm of your hand to apply swift, firm pressure to the back of each.

Chute Directional Control

1.Remove the plastic cap (if present), flat washer and hairpin clip from the end of the chute directional control. See Figure 3-21.

A

B

Figure 3-21

2.Insert the end of the chute directional control into the lower bracket and secure with the flat washer and hairpin clip just removed. If necessary, the lower bracket can be adjusted. Refer to Chute Bracket Adjustment in the Service section.

Section 3 — Assembly & Set-Up

 

13