Chute Assembly

1.Remove hairpin clip, wing nut and hex screw from chute control head and clevis pin and bow-tie cotter pin from chute support bracket. See Figure 3-3.

Chute Control Head

Chute Support

Bracket

Chute

Chute Base

Figure 3-3

2.Insert chute control rod into chute control head. Push rod as far into chute control head as possible, keeping the holes in the rod pointing upward. See Figure 3-4.

Figure 3-4

3.Place chute onto chute base and ensure chute control rod is positioned under the handle panel. Install hex bolt previously removed but do not secure with wing nut at this time. See Figure 3-5.

Figure 3-5

4.Squeeze the trigger on the joystick and rotate the chute by hand to face forward. The holes in the chute control input will be facing up. See Figure 3-6.

Chute Control

Top View

Input

 

Figure 3-6

NOTE: The chute will not rotate without squeezing the trigger on the joystick.

Section 3 — Assembly & Set-Up

 

9