Manuals / MTD / Lawn and Garden / Snow Blower

MTD 769-01275C warranty Safety Labels, Restrict the use, in this manual and on the machine

Models: 769-01275C

1 28

Download 28 pages 20.58 Kb

Page 3

Safety

��

��
��
	��
	��
	�
��	��
��	��
��	��
��	��
	��
	��
��	��
��	��
	��		��
	��		��
	��		��
��	��		��
��	��		��


��			��

��

��

��

��

��

��

��

��

��

A chute clean-out tool is fastened to the top of the

�� auger housing with a mounting clip. The tool is designed to clear a chute assembly of ice and snow.

This item is fastened with a cable tie at the factory. Cut the cable tie before operating the snow thrower.

WARNING: Never use your hands to clear a clogged chute assembly. Shut off engine and remain behind handles until all moving parts have stopped before using the clean-out tool to clear the chute assembly.

1

Safety

Labels

WARNING

This symbol points out important safety instructions which, if not followed, could endanger the personal safety and/or property of yourself and others. Read and follow all instructions in this manual before at- tempting to operate this machine. Failure to comply with these instructions may result in personal injury. When you see this symbol.

HEED ITS WARNING!

Your Responsibility

Restrict the use

of this power machine to persons who read, understand

and follow the warnings and instructions

in this manual

and on the machine.

3

Image 3

MTD 769-01275C Safety Labels, Restrict the use, in this manual and on the machine, Your Responsibility, Heed Its Warning

Contents

OPERATOR’S MANUAL Two-Stage Snow Thrower - E, F StyleMTD LLC, P.O. BOX 361131 CLEVELAND, OHIO Warranty Table of ContentsFinding and Recording Model Number Customer SupportYour Responsibility Safety LabelsRestrict the use in this manual and on the machinein this manual and on the machine Safe OperationPractices TrainingPreparationRestrict the use Maintenance & StorageSafe Operation Practices Operation3. Position the chute assembly over the base Setting Up Your Snow ThrowerSkid Shoes Setting Up Your Snow ThrowerAdjustments Auger ControlKnow Your Snow Thrower OperatingYour Snow ThrowerThis handle is used to manually start the engine Operating Your Snow ThrowerWhen engaged, the augers rotate and draw snow into the auger housing Crank clockwise to discharge to the leftElectric Starter Gas & Oil Fill-UpStopping The Engine If your home’sRecoil Starter Chute Clean-Out ToolTo Engage Drive To Engage AugersMaking Adjustments To adjust the skid shoes Making AdjustmentsWheels Maintaining Your Snow ThrowerEngine Gear Shaftproceed as follows Auger Belt Replacementreplacement auger belt Maintaining Your Snow Thrower3. a. Grasp the idler pulley and pivot it toward the right Maintaining Your Snow ThrowerMaintaining Your Snow Thrower Friction Wheel RemovalReassemble the side plates with a new rubber ring Off-Season Storage Preparing EnginePreparing Snow Thrower Remedy Trouble ShootingProblem CauseStyles E & F Illustrated Parts List To order replacement parts, contactor visit Styles E & F 631-04133 Illustrated Parts ListHandle Assembly, Clutch Lock, LH Handle Assembly, Clutch Lock, RHStyles E & F Illustrated Parts List To order replacement parts, contactor visit Page Page MANUFACTURER’S LIMITED WARRANTY FOR