AR13D RIDE-ON ROLLER — RULES FOR SAFE OPERATION
■NEVER Run engine without air cleaner. Severe engine damage may occur.
■ALWAYS read, understand, and follow procedures in Operator’s Manual before attempting to operate equipment.
■ALWAYS be sure the operator is familiar with proper safety precautions and operations techniques before using roller.
■ALWAYS store equipment properly when it is not being used. Equipment should be stored in a clean, dry location out of the reach of children.
■DO NOT operate this roller with hydrostatic oil temperature higher than 180 degrees fahrenheit.
■NEVER leave the roller unattended, turn off engine and place parking brake lever in upright position.
■CAUTION must always be observed while servicing this roller. Rotating parts can cause injury if contacted.
■DO NOT leave roller with engine running.
■If the roller must be stopped on an incline (grade), remove the ignition key and place chock blocks (not provided) under the front and rear drums.
■NEVER drive the roller on unshored trenches or near steep, unsupported banks.The vibration caused by the roller could cause a
■ALWAYS use extreme care when operating near obstructions, on slippery surfaces, grades and side slopes.
■ALWAYS wear slip resistant safety shoes or boots.
■Unauthorized equipment modifications will void all warranties.
■When working on slopes, avoid sidehill travel. Operate up and down travel only. Remember, the danger of sliding on and/or tripping on steep slopes is always present.
■ALWAYS wear seat belts.
■When malfunctions occur, always remove the ignition key and place a "DO NOT OPERATE " sign in the operator's seat.
■If a malfunction occurs with the travel lever mechanism, speed and direction will be impossible to control. Immediately stop the roller and correct the problem.
■If the steering system operates improperly, immediately stop the engine and apply the parking brake.
■In the event of hydraulic hose or line failure, promptly return the travel lever to the “neutral” position, stop the engine and set the parking brake.
MAINTENANCE SAFETY
■NEVER lubricate components or attempt service on a running machine.
■ALWAYS allow the machine a proper amount of time to cool before servicing.
■Keep the machinery in proper running condition.
■Fix damage to the machine immediately and always replace broken parts, or missing decals.
■Dispose of hazardous waste properly.Examples of potentially hazardous waste are used motor oil, fuel and fuel filters.
■DO NOT use food or plastic containers to dispose of hazardous waste.
■DO NOT pour waste, oil or fuel directly onto the ground, down a drain or into any water source.
AR13D
