Multiquip operation manual CA4HCTROWEL — INITIAL START-UP, Stopping The Engine, Starter Grip

CA4HCTROWEL — INITIAL START-UP

6.Grasp the starter grip (Figure 21) and slowly pull it out.The resistance becomes the hardest at a certain position, corre- spondingtothecompressionpoint.Pullthestartergripbriskly and smoothly for starting.

Stopping The Engine

1.Movethethrottlelever tothe IDLE orSLOWposition (Figure 22) and run the engine for three minutes at low speed.

2.Aftertheenginecools,turntheenginestart/stopswitchtothe “OFF” position (Figure 23).

Figure 21. Starter Grip

7.If the engine has started, slowly return the choke lever (Figure19)totheOPENposition.Iftheenginehasnotstarted repeat steps 1 through 6.

8.Before the trowel is placed into operation, run the engine for severalminutes. Check for fuel leaks, and noises that would associate with a loose V-belt cover or component.

9.To begin troweling, move the throttle lever (Figure 22) toward the "FAST" position.

Figure 23. Engine ON/OFF Switch (OFF Position)

3.Closethefuelshut-offvalve(Figure24)bymovingthefuel valve lever to the OFF position.

Figure 24. Fuel Valve Lever (OFF Position)

Figure 22. Throttle Lever (Run Position)

PAGE 24 — CA4HC WALK-BEHIND TROWEL— OPERATION MANUAL — REV. #0 (09/29/06)