Installing Pans Onto Finisher Blades
WARNING
ALWAYS install pans either on the work area or on an area that is next to and level with the work area. DO NOT lift the trowel when the pans are attached.
Refer to Figure 35 when installing pans onto finisher blades.
2
3
1
4
1Blade Assembly
2Knob,
3Tie-down, Blade
4
Figure 35. Pan Installation
CA4HCTROWEL — MAINTENANCE
1.Lift trowel just enough to slide pan under blades. Lower finisher onto pan with blades (item #1) adjacent to
2.Rotate blades into position under
3.Attach the blade
4.Check to make certain that the blade edges are secured under the
Decommissioning Trowel/Components
Decommissioning is a controlled process used to safely retire a pieceofequipmentthatisnolongerserviceable. Iftheequipment poses an unacceptable and unrepairable safety risk due to wear or damage or is no longer cost effective to maintain, (beyond life- cycle reliability) and is to be decommissioned, (demolition and dismantlement), the following procedure must take place:
1.Drain all fluids completely. These may include oil, gasoline, hydraulic oil and antifreeze. Dispose of properly in accor- dance with local and governmental regulations. Never pour on ground or dump down drains or sewers.
2.The remainder can be brought to a salvage yard or metal reclamation facility for further dismantling.
PAGE 30 — CA4HC