Multiquip DCA125SSIU manual Generator SHUT-DOWN Procedures, Normal Shutdown Procedure

GENERATOR SHUT-DOWN PROCEDURES

WARNING

NEVER stop the engine suddenly except in an emergency.

NORMAL SHUTDOWN PROCEDURE

To shutdown the generator, use the following procedure:

1.Place both the MAIN, GFCI and LOAD circuit breakers as shown in Figure 35 to the OFF position.

2.Place the engine speed switch (Figure 53) in the “LOW” (down) position.

EMERGENCY SHUTDOWN PROCEDURE

1.Place the ECU Control Switch switch (Figure 54) to the OFF/Reset position.

2.To shut-down the engine in the event of an emergency, switch the MAIN, GFCI and LOAD (Figure 38) circuit breakers to OFF position.

Figure 53. Engine Speed Switch (Low)

3.Let the engine cool by running it at low speed for 3-5 minutes with no load applied.

4.Place the MPEC Control Switch (Figure 54) to the OFF/RESET position.

Figure 54. MPEC Control Switch (Off/Reset)

5.Verify that all the status LEDs on the MPEC display are OFF (not lit).

6.Remove all loads from the generator.

7.Inspect entire generator for any damage or loosening of components that may have occurred during operation.

DCA125SSIU 60 HZ GENERATOR • OPERATION AND PARTS MANUAL — REV. #3 (01/13/11) — PAGE 37