FS3SP CONCRETE SAW — MAINTENANCE
CAUTION:
General maintenance practices are crucial to the performance and longevity of your saw.The extreme environments of sawing operations require routine cleaning, lubrication, belt tensioning, and inspection for wear and dam- age
WARNING
The following procedures devoted to mainte- nance can prevent serious saw damage or malfunctioning. Before servicing or inspection, ALWAYS park the saw on a level surface with
the blade removed, and the Console Engine ON/OFF switch & Engine ON/OFF switch in “OFF” position.
WARNING
Some maintenance operations may require the engine to be run. Ensure that the mainte-
nance area is well ventilated. Exhaust contains poisonous car- bon monoxide gas that can cause of unconsciousness and may result in DEATH
General Engine Care
1.ENGINE CHECK: Check daily for any oil and/or fuel leakage, thread nut & bolt tightness, and overall cleanliness.
2.ENGINE OIL: Check daily. Inspect with blade removed and saw frame level on a level surface. Keep the oil clean, and at the proper servicing level (Figure 7).DO NOT OVERFILL! SAE
3.ENGINE OIL CHANGE: Change engine oil the first month or 20 hours of operation.Then every 3 months/ or 50 HOURS
NOTE
ALWAYS dispose of used oil in a responsible manner.Ensure that the disposition of all hazardous waste is handled properly. Call your Recycling Center for information about recycling engine oil.
4.ENGINE AIR FILTER: Clean air filter 2 TO 3 times daily when DRY cutting.See Engine Owner’s Manual for detailed information.
5.ENGINE TANK & STRAINER: Clean every year/ or 300 hours.
6.FUEL LINE: Replace every two years/ or as necessary.
7.SPARK PLUG: Clean/adjust every 6 months/or 100 hours. Replace every year/ or 300 hours.
Bearing Lubrication Care
There are seven (7) grease points for the FS3SP Push Model saw, and nine (9) grease points for the FS3SP
1.Front Wheels (2): Grease daily, see page 42, item 3, Undercarriage Assembly.
2.RearWheels (2): Grease daily, see page 44, item 10, Rear Axle Assembly.
3.Blade Shaft Bearings (2): Grease daily, see page 46, item6, Blade Shaft Assembly.
4.Raise/Lower AdjustTube (1): Grease daily, see page 58, item 20, Raise/Lower Assembly.
5.Transmission Shaft Bearings (2): Grease weekly, see page 68, item 16,Transmission Assembly.
NOTE
When cutting DRY, lubricate blade shaft bearings 2 to 3 times daily. The grease can provide an added protective seal for the bearings.
