Multiquip FS3SP Engine Oil Dip Stick, Engine Oil Limits, Engine Oil Filler and Cap

FS3SP CONCRETE SAW — ENGINE COMPONENTS

Figure 7. Engine Controls and Components

4. Engine Oil – (See figure 7)

A. Engine Oil Dip Stick

■Remove the dipstick and wipe clean.

■Fully insert the dipstick; Then remove it to check the oil level.

B. Engine Oil Limits

■Check Oil Level. If the level is low, fill to the upper limit mark on the dipstick with the recommended oil.

■Reinstall the dipstick and screw the oil filter cap securely.

C.Engine Oil Filler and Cap.

Ensure that the mouth of the oil filler is kept clean and that the cap is secure after servicing.

5.	Electric Starter – Engine Start is electrically actuated by
	12Volt DC system.Starter button, choke,Throttle Handle,
	and Engine On/Off Switches are conveniently located
	on the operating console. (See figure 5)
6.	Oil Filter – A "Spin On/Off" type oil filter is utilized. It is
	recommended that the filter be replaced every (year / or
	200 hours of operation). Oil Filter tightening torque is
	approximately 16 ft-lb. (22 N-m, 2.2 kg-m)

NOTICE

Use only genuine Honda filters or a filter of equivalent quality which is specified by the engine model. Using the wrong filter, or a non-Honda quality equivalent, may cause engine damage.

D.	Engine Drain Bolt.	7.	Muffler – A high-mount muffler (type "8") is utilized to
■	Drain the used oil while the engine is still warm.		reduce noise and emissions; as well as deflect engine
	Place suitable container to catch the used oil		exhaust away from the operator.
	before removing the Engine Drain Bolt.

■Allow used oil to drain completely and then reinstall oil drain bolt and tightly secure.

■Refer to "A. & B." above for Oil Refil.

NOTICE

Dispose of used motor oil in a manner that is compatible with the environment and the Local, State, & Federal laws.

WARNING

Engine components can generate extreme heat. To prevent burns, do not touch these areas while the engine is running or immediately after operations. Never operate the engine with the muffler removed.

PAGE 18 — MQ-WHITEMAN FS3SP CONCRETE SAW — PARTS & OPERATION MANUAL — REV. #0 (07/15/02)